The supply of sand and gravel allowed society to develop rapidly. The construction of urban viaducts, the rapid construction of highways, and the development of roads and railways all require raw materials to be processed through crushers. Only qualified materials can be put into construction. Therefore, the supply of sand and gravel has allowed society to experience a stage of rapid development, and the supply of gravel has also become a popular industry! So what issues should we pay attention to when configuring a reasonable crushing production line?
1. Raw materials
When designing a stone production line, it is necessary to consider the hardness, mud content, moisture content, silicon content, crushing work index, etc. of the material. For different materials, the equipment types selected are not exactly the same.
2. Raw material size
The particle size of raw materials refers to the size of materials entering primary crushing, and the particle size of raw materials determines the selection of primary crushing equipment.
3. Specifications, proportions, uses, etc. of finished aggregates
Different crushing equipment has different crushing effects, so it is necessary to make reasonable selection according to the actual production needs of the user.
4. Output
Only when the output is accurate to the hour can the production line be accurately selected.
5. The equipment configured in the production line must be matched before and after
1) Whether the particle size of the material crushed in the previous stage matches the feed particle size of the next stage crushing equipment.
2) Whether the throughput is consistent under the premise of meeting the crushing granularity.
3) Whether the conveyor belt matches the electronic control system.
6. Can you guarantee full production for each piece of equipment?
When selecting the configuration of a crushing production line, it is necessary to fully consider the specific factors that affect various types of crushing equipment, and select appropriate crushing equipment for different material processing. Generally speaking, for crushing a series of brittle materials with low Mohs hardness such as limestone, talcum powder, cement, etc., it is recommended to use jaw crusher and impact crusher. For granite, etc., it is recommended to use high-quality soldering iron and high-wear-resistant equipment. Wear-resistant parts, such as cone crusher, are produced, and then the stone production line is reasonably adjusted.
A reasonable crushing production line must consider the mutual cooperation between various equipment. Only with reasonable design and good cooperation between various equipment can greater production value be created.